Jialian conveyor climbing belt machine explain

Climbing conveyor is suitable for outdoor and indoor installation. It can be used for cargo turnover between floors. It can be used for both goods and goods. It is used for food, chemical industry, hardware, toys, household appliances, etc. If the factory does not have elevator, it can be used for climbing. Conveyor to the goods under the goods. There are elevators can also install this equipment. Because the goods under the elevator is too slow, the efficiency is not high. If you use the climbing conveyor to the goods on the goods more convenient.

Jialian conveyor climbing belt machine detailed structure:

Power uses 3HP Chengbang motor, with 1:60 gearbox, transmission speed of 1 to 5 meters per minute per minute, adjustable speed: 3HP love profit inverter.
Body size: 40 * 200, using 3 mm cold plate production, appearance sky blue.
The conveyor is a 3 mm galvanized chain plate, 650 mm long, 95 mm wide, and 1 inch big ball with side ear chain.
100 mm on both sides with transport baffle, 1 m pitch, the bottom with small diameter wheels 200 at both ends thereof with a wire emergency stop switch.
The angle with the ground is less than 30 degrees.

Climbing belt conveyor should pay attention to the following points:
1, clean up the site of environmental health, and need to bond the skirt, rubber adhesive surface and the belt surface clean.
2. Use a polishing machine to evenly and thinly beat the belt, skirt, etc., and clean it. However, the belt canvas or the hair-driving area cannot be uneven.
3, before the brushing glue, the hardening agent attached to the adhesive is uniformly mixed according to a certain proportion, so that the dispensed glue has the advantages of fast curing, strong adhesive force, heat resistance, aging resistance, and no need of heating, fixing and pressing. Features.
4, brush glue coating is to be strong, thin and uniform coating, if the belt canvas layer or other fiber fabric layer, or fight hair at the rubber off the obvious, to brush more than three layers.
5. When the coating is dry to the point where it does not stick to the back of the hand, gradually press the skirt or glue onto the coating, and at the same time use a hammer to orderly strike from the middle to the edge to eliminate the internal air.
Application range of climbing conveyors:

(1) The climbing conveyor is a general-purpose continuous conveying equipment for bulk materials, but a conveyor belt with corrugated ribs and diaphragms is used. Therefore, it is especially suitable for large angle and vertical 90° conveying.
(2), climbing conveyor can be used in coal, chemical, metallurgy, electric power, light industry, food, port and other industries, in the working environment temperature is -15 °C ~ +40 °C within the scope of transport accumulation of 0.5-4.2t /m3 of various bulk materials.
(3) Special conveyor belts are required for the transportation of materials with special requirements, such as materials with high temperature, acids, alkalis, oils, or organic solvents.
(4) In the range of 0° to 90°, the maximum vertical conveying material size is 400mm.

Climbing conveyor main features:

(1) The bulk material can be transported at a large angle, which can save a lot of equipment area and completely solve the conveying angle that can not be achieved by ordinary and pattern belt conveyors.
(2) Mechanized belt conveyors transport materials with low overall investment costs, saving about 20% to 30% of investment costs.
(3) Compared with common belt conveyors, bucket elevators and scraper conveyors, this model has superior comprehensive technical performance.
(4) Large transport volume, up to 6000m3/h, vertical lifting height up to 500m.
(5) When the material is conveyed vertically, the particle size of the material can reach up to 400mm.
(6) Smooth transition from horizontal to inclined (or vertical).
(7) Low energy consumption, simple structure, easy maintenance