[ Chinese wardrobe network ] For a friend who rents a house, a simple cloth wardrobe is a good choice, which can save the room area, and the price is low, and the disassembly and installation are very convenient. That is to say, when you move, you will not lose too much. Below, Xiaobian will introduce you to the installation method of the simple cloth wardrobe in detail, and friends who are interested can come and find out!

Simple cloth wardrobe

Simple Cloth Wardrobe Installation - Check Packaging and Accessories

First of all, when receiving the goods, whether it is express or direct purchase, be sure to check whether the packaging is seriously damaged. If there is, it is likely that the steel pipe inside is also crushed. Such goods must not be signed and purchased. Check clearly. Open the package, and then check whether the accessories inside are complete. There is a manual, check the instructions. If there are few, it is estimated that you can't install it without using it. Therefore, the number is clear in advance, so as not to be wasted. When installing, it must be Wear gloves and be sure to read the instructions carefully.

Simple cloth wardrobe installation - cloth bottom installation

First install the bottom one, take out the four-way joint with the bottom and the high, and connect with the short tube in the middle. Install a four-way joint on each side, then install the tube on both sides, decide the position of the place, and install the long tube. Short tube. Then install the base fabric on both sides, and then install a three-way joint around each other. After installing the bottom, insert six short steel pipes, and then put the whole wardrobe cloth up against the surrounding holes. Then install a layer of partition like the bottom, and then put it on the six steel pipes.

Simple cloth wardrobe installation - cloth wardrobe steel pipe installation

If the wardrobe is divided on two sides, first install the short-side floor, first insert the side steel pipe, then install the cloth, then connect the four-way joint, then install two horizontal steel pipes, then install the cloth, then Then make up the four-way joint on both sides. Repeat the baffle until it is attached to the top. After the short side baffle is installed, the long side is a vertical hanging area with a three-way joint connecting the two long Tube, until the top. After both sides are installed, connect them directly with long steel pipes, so that the wardrobe is installed. If the wardrobe is too high and not enough to squeeze, it is recommended to push the side backwards so as not to be installed. It can also be mounted with a hook connector, which is relatively simple. When setting the top cover, it is best to pull the bottom to the top so that there is space to pull up until the top corner is installed. At this time, the cloth cover can be pulled down. The wardrobe is installed.

The above is the installation method of the simple cloth wardrobe introduced by Xiaobian. Is it very simple? Here Xiaobian wants to remind the consumers that even the price of the simple cloth wardrobe is not high, but when choosing the cloth wardrobe, Pay attention to the quality of the cloth wardrobe, and choose the products produced by regular manufacturers as well. Only in this way can the cloth wardrobe have a sufficient service life.

Basin Faucets

Basin Faucets,Vanity Taps,Wash Basin Faucet,Face Basin Faucet

Hangzhou LvDong Building Materials Co., Ltd , https://www.ldunite.com