Digital printing and post-press three operating experience

In the post-printing process of digital printing, since the digital printing products have different characteristics from the traditional printing products, there are many places that need attention. In the current edition of Beijing Zhixian Tuofang Science and Technology Development Co., Ltd., the teacher of the post-print department, Yang Qinghong, provided readers with 3 experiences.

Experience one: It is not appropriate to film immediately after printing

Process Description: The film is a printed matter that covers the surface of the printed matter with a plastic film to form a paper-plastic one. A layer of transparent plastic film covers the printed surface to enhance the brightness of the printed surface, and it is resistant to wear, water, heat, and dirt.

Description of the problem: After the film is coated on a digital printing product, the printing product will appear blistering. This is because the ink layer in the digital printing usually contains silicone oil, and the adhesive cannot normally penetrate the ink layer.

Solution: Adjust some of the processes in the digital printing production process, try to allow the printed products to be placed on the film after printing for a period of time.

Experience 2: Die-cutting, indentation emphasizes precision

Process Description: The specific use of paper or paperboard in accordance with a certain specification, with a knife cut into a certain shape of the method of die-cutting; the use of steel wire according to a certain size, in the paper or cardboard impressions in order to use this impression to put the paper Or cardboard bending, this method is called indentation.

Description of the problem: At present, with the development of personalized products, small quantities, and variable requirements for packaging products, some packaging products are also digitally printed. The bending and indentation of packaging products need to be achieved by die cutting and indentation processes. The unacceptable problems of die-cutting, indentation common specifications, skewed or overlapping finished products, etc. are mostly related to inaccurate dimensions.

Solution: Computation size, etc. must be calculated strictly in accordance with the customer's processing requirements, and a real sample should be made for measurement and review so as to avoid the use of errors and cause greater losses.

Experience 3: The temperature of hot melt adhesive must be mastered

Process Description: Binding is to print a good paper, including illustrations, covers, etc., according to the different specifications of the original folded into a signature, after the flattening, gluing, cutting and a series of processing procedures, and finally made into a book process. The process is simple, the technology is mature, the cost is low, and the binding efficiency is high.

Description of the problem: The quality of the bookbinding is directly related to the quality and appearance of the books and periodicals. Excessive temperatures may cause aging of the rubber compound and no effect. The temperature is too low, and problems such as stickiness and paper jam may occur.

Solution: When using hot melt adhesive, heat the hot melt adhesive to a certain temperature before production, generally controlled between 150 ~ 200 °C, the best temperature is 170 ~ 180 °C and to maintain the temperature stability.

Reproduced from: newmaker