This kit can only be used for scientific research, not for medical diagnosis. Quantitative detection kit for mouse nuclear factor kb receptor activating factor ligand (RANKL) (ELISA) instruction manual ã€Mouse Nuclear Factor kb Receptor Activating Factor Ligand (RANKL) Elisa Kit Kit Name】 Quantitative Detection Kit (ELISA) for Mouse Nuclear Factor kb Receptor Activating Factor Ligand (RANKL) ã€Mouse nuclear factor kb receptor activation factor ligand (RANKL) Elisa kit kit uses】 Quantitative detection of the content of nuclear factor kb receptor activating factor ligand (RANKL) in mouse serum, plasma and related liquid samples. [The detection principle of mouse nuclear factor kb receptor activating factor ligand (RANKL) Elisa kit] This kit uses double-antibody two-step sandwich enzyme-linked immunosorbent assay (ELISA). Add the standard and the test sample to the pre-coated mouse nuclear factor kb receptor activating factor ligand (RANKL) monoclonal antibody clear enzyme label coated plate, after incubation for a sufficient time, wash to remove unbound components, Add enzyme working solution again, and after incubation for a sufficient time, wash to remove unbound components. Substrates A and B are added in sequence, and the substrate (TMB) is converted into a blue product under the catalysis of horseradish peroxidase (HRP), which becomes yellow under the action of acid. The concentration of receptor activation factor ligand (RANKL) was positively correlated. The OD value was measured at a wavelength of 450 nm. Based on the OD value of the standard and the sample, the content of mouse nuclear factor kb receptor activation factor ligand (RANKL) in the sample was calculated. [Mouse Nuclear Factor kb Receptor Activating Factor Ligand (RANKL) Elisa Kit Composition] 1 Enzyme label coated plate 12 well × 8 strips 7 Developer A solution 6mL 2 Standard 0.3mL × 6 tubes 8 developer B solution 6mL 320 times concentrated washing liquid 25mL9 stop solution 6mL 4 sample dilutions 6mL10 instruction manual 1 5 special diluent 6mL11 sheet sealing film 2 sheets 6 enzyme label reagent 6mL12 sealed bag 1 Remarks: The concentration of standard products (No. 1 → No. 6) is: 600, 300, 150, 75, 37.5, 18.75 pmol / L [Reagents and equipment not required by mouse nuclear factor kb receptor activating factor ligand (RANKL) Elisa kit] 1. 37 ℃ thermostat 2. Standard specification microplate reader 3. Precision pipettes and disposable tips 4. Distilled water 5. Disposable test tubes 6. Absorbent paper [Mouse Nuclear Factor kb Receptor Activating Factor Ligand (RANKL) Elisa Kit Procedure] 1. Preparation: Remove the reagent kit from the refrigerator and re-equilibrate at room temperature for 30 minutes. 2. Mixing solution: dilute the 20-fold concentrated washing solution with distilled water to the original one. 3. Add standard products and samples to be tested: take a sufficient number of enzyme-coated plates and fix them to the frame. Set up standard wells, test sample wells and blank control wells respectively. Add 50μL of standard product; first add 10μL of sample to be tested, then add 40μL of sample diluent (that is, the sample is diluted 5 times); blank control well is not added. 4. Incubation: Incubate in a 37 ° C water bath or thermostat for 30 minutes. 5. Wash the plate: discard the liquid, pat dry on the absorbent paper, fill each well with the washing liquid, let stand for 1min, shake off the washing liquid, pat dry on the absorbent paper, repeat the washing plate 4 times (you can also use the washing machine to press Instructions for washing the board). 6. Add enzyme-labeled working solution: add 50μL of enzyme-labeled working solution to each well, without adding blank control wells. 7. Incubation: Incubate in a 37 ° C water bath or thermostat for 30 minutes. 8. Plate washing: Discard the liquid, pat dry on the absorbent paper, fill each hole with the washing liquid, let stand for 1min, shake off the washing liquid, pat dry on the absorbent paper, repeat the plate washing 4 times (you can also use the washing machine to press Instructions for washing the board). 9. Color development: add 50μL of developer A solution to each well, and then add 50μL of developer B solution. Mix with a plate mixer for 30s (or shake gently by hand for 30s), and avoid color development at 37 ℃ for 15min . 10. Termination: Remove the enzyme labeling plate and add 50μL of stop solution to each well to stop the reaction (the color changes from blue to yellow). 11. Determination: Zero the blank holes, and within 15 minutes after termination, measure the absorbance (OD value) of each well with a wavelength of 450 nm. 12. Calculation: According to the concentration of the standard product and the corresponding OD value, calculate the linear regression equation of the standard curve, and then calculate the corresponding sample concentration on the regression equation according to the OD value of the sample. You can also use various application software to Calculation. The final concentration is the actual measured concentration times the dilution factor. [Mouse Nuclear Factor kb Receptor Activating Factor Ligand (RANKL) Elisa Kit Sample Requirements] 1. The sample cannot contain sodium azide (NaN3) because sodium azide (NaN3) is an inhibitor of horseradish peroxidase (HRP). 2. The specimen should be extracted as soon as possible after collection. The extraction should be carried out according to relevant literature. The experiment should be carried out as soon as possible after extraction. If the test cannot be performed immediately, the specimen can be stored at -20 ℃, but repeated freezing and thawing should be avoided. 3. The sample should be fully centrifuged, without hemolysis and particles. [Precautions for Elisa kit of mouse nuclear factor kb receptor activating factor ligand (RANKL)] 1. The experiment is carried out in strict accordance with the instructions, and the result of the experiment must be determined by the reading of the microplate reader. 2. If the enzyme-labeled coated board is not used up after opening, it should be put into a sealed bag and added with desiccant immediately. 3. It is recommended that all standards, samples and blank controls be tested in duplicate, and the average value is taken to reduce the experimental error. 4. Keep in mind that the sample has been diluted 5 times. The calculation result is multiplied by 5 to obtain the actual concentration of the sample. 5. The quantitative range of this kit is 18.75-600pmol / L, beyond this range, it is calculated from the extension of the standard curve. ), Multiplied by the total dilution factor is the final concentration of the sample. 6. If the color is too light, the substrate incubation time can be extended properly. 7. In order to avoid cross-contamination, the tips, samples and blank controls should be replaced with a new one for each addition; the common components such as enzyme working solution, sample dilution and substrate should be cantilevered and not touch the microwell ; Do not reuse the sealing film. 8. The kits are used within the warranty period, and different batches of reagents should not be mixed. 9. Substrate B is sensitive to light and avoid prolonged exposure to light. [Mouse nuclear factor kb receptor activating factor ligand (RANKL) Elisa kit operating procedures summary] Prepare reagents, samples and standards Add prepared samples and standards, and react at 37 ℃ for 30 minutes Wash the plate 4 times, add the enzyme reagent, and react at 37 ℃ for 30 minutes Wash the plate 4 times, add color developing solutions A and B, and develop at 37 ℃ for 15 minutes Add stop solution Read OD value within 15 minutes Calculation [The detection range of mouse nuclear factor kb receptor activating factor ligand (RANKL) Elisa kit] 18.75pmol / L-600pmol / L ã€Specification of mouse nuclear factor kb receptor activating factor ligand (RANKL) Elisa kit】 96 servings / box [Storage of mouse nuclear factor kb receptor activating factor ligand (RANKL) Elisa kit] Store at 2-8 ℃, protected from light and moisture. [Mouse Nuclear Factor kb Receptor Activating Factor Ligand (RANKL) Elisa Kit Validity Period] 6 months
Features: It's high quality and high pigment cream blush. It's vegan and cruelty free. We don't do animal test when make products.
Usage: Dip a little blush with your fingers or sponge egg, then apply it on your cheeck. It can be used for daily makeup to make you look refreshed.
Advantages: Our company is a comprehensive cosmetics enterprise integrating research,development production, sales and service, which is a professional manufacturer of cosmetics. We provide custom service. We can customize your colors and logo. Making high quality products is our aim.
Delivery: It would take around 15-20 days to finish the custom products after we confirm the order.
It would take around 7-10 days to finish the products which don't need to be customed.
Payment: We can accept the payment through T/T ($25 extra for each payment).
custoom blush,liquid blush,makeup blush,hot selling blush Suzhou Yimeijia368 Biological Technology Co.,Ltd. , https://www.ymjbeauty.com
