Shanghai Yiji Industrial Co., Ltd. is a limited liability company that integrates distribution, wholesale and investment promotion, and is an enterprise approved and registered by the relevant state departments. Mainly engaged in ELISA kits, cells, serum, antibodies, biological reagents, culture media, and other products, please call for details. Porcine Transforming Growth Factor β2 (TGF-β2) Quantitative Detection Kit (ELISA) user's Guide ã€Porcine Transforming Growth Factor β2 (TGF-β2) Elisa Kit Kit Name】 Porcine Transforming Growth Factor β2 (TGF-β2) Quantitative Detection Kit (ELISA) ã€Porcine Transforming Growth Factor β2 (TGF-β2) Elisa Kit Kit Usage】 Quantitative detection of transforming growth factor β2 (TGF-β2) in swine serum, plasma and related liquid samples. [Porcine Transforming Growth Factor β2 (TGF-β2) Elisa kit detection principle] This kit uses double-antibody two-step sandwich enzyme-linked immunosorbent assay (ELISA). Add the standard and the test sample to the pre-coated porcine transforming growth factor β2 (TGF-β2) monoclonal antibody clear enzyme label coating plate. After incubation for a sufficient time, wash to remove unbound components, and then add the enzyme label After incubating the working solution for a sufficient period of time, wash to remove unbound components. Substrates A and B are added in sequence, and the substrate (TMB) is converted into a blue product catalyzed by horseradish peroxidase (HRP), which turns yellow under the action of an acid. The concentration of β2 (TGF-β2) was positively correlated. The OD value was measured at a wavelength of 450 nm. Based on the OD value of the standard and the sample, the content of porcine transforming growth factor β2 (TGF-β2) in the sample was calculated. [Porcine Transforming Growth Factor β2 (TGF-β2) Elisa Kit Kit Composition] 1 Enzyme coated plate 12 holes × 8 7 Developer A liquid 6mL 2 Standard 0.3mL × 6 tubes 8 Developer B liquid 6mL 3 20 times concentrated washing liquid 25mL 9 Stop solution 6mL 4 Sample diluent 6mL 10 Instructions 1 serving 5 Special diluent 6mL 11 Sealing film 2 sheets 6 Enzyme reagent 6mL 12 sealed bag 1 Remarks: The concentration of standard products (No. 1 → No. 6) is: 800, 400, 200, 100, 50, 25 ng / L ã€Pig Transforming Growth Factor β2 (TGF-β2) Elisa kit required but not provided reagents and equipment】 1. 37 ℃ thermostat 2. Standard specification microplate reader 3. Precision pipettes and disposable tips 4. Distilled water 5. Disposable test tubes 6. Absorbent paper ã€Procedures of Porcine Transforming Growth Factor β2 (TGF-β2) Elisa Kit】 1. Preparation: Remove the reagent kit from the refrigerator and re-equilibrate at room temperature for 30 minutes. 2. Mixing solution: dilute the 20-fold concentrated washing solution with distilled water to the original one. 3. Add standard products and samples to be tested: take a sufficient number of enzyme-coated plates and fix them to the frame. Set up standard wells, sample wells to be tested and blank control wells, record the positions of each well in the standard wells. Add 50μL of standard product; first add 10μL of the sample to be tested, then add 40μL of sample diluent (that is, the sample is diluted 5 times); the blank control well is not added. 4. Incubation: Incubate in a 37 ° C water bath or thermostat for 30 minutes. 5. Wash the plate: discard the liquid, pat dry on the absorbent paper, fill each well with the washing liquid, let stand for 1min, shake off the washing liquid, pat dry on the absorbent paper, repeat the washing plate 4 times (you can also use the washing machine to press Instructions for washing the board). 6. Add enzyme-labeled working solution: add 50μL of enzyme-labeled working solution to each well, without adding blank control wells. 7. Incubation: Incubate in a 37 ° C water bath or thermostat for 30 minutes. 8. Plate washing: Discard the liquid, pat dry on the absorbent paper, fill each hole with the washing liquid, let stand for 1min, shake off the washing liquid, pat dry on the absorbent paper, repeat the plate washing 4 times (you can also use the washing machine to press Instructions for washing the board). 9. Color development: add 50μL of developer A solution to each well, and then add 50μL of developer B solution. Mix with a plate mixer for 30s (or shake gently by hand for 30s), and avoid color development at 37 ℃ for 15min . 10. Termination: Remove the enzyme labeling plate and add 50μL of stop solution to each well to stop the reaction (the color changes from blue to yellow) 11. Determination: Zero the blank holes, and within 15 minutes after termination, measure the absorbance (OD value) of each well with a wavelength of 450 nm. 12. Calculation: According to the concentration of the standard product and the corresponding OD value, calculate the linear regression equation of the standard curve, and then calculate the corresponding sample concentration on the regression equation according to the OD value of the sample. You can also use various application software to Calculation. The final concentration is the actual measured concentration times the dilution factor. [Porcine Transforming Growth Factor β2 (TGF-β2) Elisa kit sample requirements] 1. The sample cannot contain sodium azide (NaN3) because sodium azide (NaN3) is an inhibitor of horseradish peroxidase (HRP). 2. The specimen should be extracted as soon as possible after collection. The extraction should be carried out according to relevant literature. If the test cannot be performed immediately, the specimen can be stored at -20 ℃, but repeated freezing and thawing should be avoided. 3. The sample should be fully centrifuged, without hemolysis and particles. ã€Precautions for Porcine Transforming Growth Factor β2 (TGF-β2) Elisa Kit】 1. The experiment is carried out in strict accordance with the instructions, and the result of the experiment must be determined by the reading of the microplate reader. 2. If the enzyme-labeled coated board is not used up after opening, it should be put into a sealed bag and added with desiccant immediately. 3. It is recommended that all standards, samples and blank controls be tested in duplicate, and the average value is taken to reduce the experimental error. 4. Keep in mind that the sample has been diluted 5 times. The calculation result is multiplied by 5 to obtain the actual concentration of the sample. 5. The quantitative range of this kit is 25-800ng / L. If it exceeds this range, it is calculated by the extension of the standard curve. ), Multiplied by the total dilution factor is the final concentration of the sample. 6. If the color is too light, the substrate incubation time can be extended properly. 7. In order to avoid cross-contamination, the tips, samples and blank controls should be replaced with a new one for each addition; the common components such as enzyme working solution, sample diluent and substrate should be cantilevered, and they should not touch the microwells. ; Do not reuse the sealing film. 8. The kits are used within the warranty period, and different batches of reagents should not be mixed. 9. Substrate B is sensitive to light and avoid prolonged exposure to light. ã€Summary of operating procedures of porcine transforming growth factor β2 (TGF-β2) Elisa kit】 Prepare reagents, samples and standards Add prepared samples and standards, and react at 37 ℃ for 30 minutes Wash the plate 4 times, add the enzyme reagent, and react at 37 ℃ for 30 minutes Wash the plate 4 times, add color developing solutions A and B, and develop at 37 ℃ for 15 minutes Add stop solution Read OD value within 15 minutes Calculation ã€Porcine Transforming Growth Factor β2 (TGF-β2) Elisa kit detection range】 25ng / L-800ng / L ã€Specification of Porcine Transforming Growth Factor β2 (TGF-β2) Elisa Kit】 96 servings / box ã€Storage of Porcine Transforming Growth Factor β2 (TGF-β2) Elisa Kit】 Store at 2-8 ℃, protected from light and moisture. ã€Porcine Transforming Growth Factor β2 (TGF-β2) Elisa Kit Validity Period】 6 months Outdoor furniture refers to furniture used for outdoor environment, mainly used for outdoor leisure, entertainment and dining activities. The classification of outdoor furniture can be divided according to the material, function and shape. Outdoor Table,Rattan Table,Rattan Chair,Beach Furniture Foshan Shengshi Zhihui Technology Co., Ltd. , https://www.officeroutdoorfurniture.com
This kit can only be used for scientific research, not for medical diagnosis.
First, classification by material
1. Wooden outdoor furniture: Wooden outdoor furniture is usually made of natural wood, such as teak. Wooden furniture has a natural, rustic character and is suitable for outdoor Spaces such as gardens, terraces and courtyards.
2. Metal outdoor furniture: Metal outdoor furniture is usually made of iron, aluminum, stainless steel and other metal materials. Metal furniture has the characteristics of durability and stability, suitable for long-term use in outdoor environment.
3. Cloth outdoor furniture: Cloth outdoor furniture is usually made of waterproof, sun protection and other special treatment of fabric. Fabric furniture with soft, comfortable characteristics, suitable for use in outdoor leisure areas.
Second, Classification by function
1. Leisure Chair: Leisure chair is the most common kind of outdoor furniture, usually used for outdoor leisure, sunbathing and other activities. There are a variety of leisure chairs, folding chairs, recliners, rocking chairs and so on.
2. Dining Table And Chair: Dining table and chair are mainly used for outdoor dining, usually consisting of a table and several chairs. Dining tables and chairs of various styles, there are round tables, square tables, etc., suitable for different venues and the number of people dining needs.
3. Parasol: Parasol is used for outdoor shading, which can effectively block direct sunlight and provide a cool resting environment. There are various styles of sunshade umbrellas, including ordinary umbrellas, large umbrellas, and rotating umbrellas.
Third, Classification by shape
1. Chairs: including ordinary chairs, rocking chairs, recliners, etc., suitable for outdoor leisure and sun.
2. Table category: including dining table, coffee table, side table, etc., suitable for outdoor dining and placing items.
3. Sofa category: including single sofa, double sofa, combination sofa, etc., suitable for outdoor leisure and parties.
4. Reclining chairs: including hammocks, reclining chairs, etc., suitable for outdoor naps and rest.
5. Queue class: including benches, benches, etc., suitable for outdoor queuing and waiting.
In summary, the classification of outdoor furniture can be divided according to material, function and shape. Different outdoor furniture is suitable for different outdoor environment and activity needs, choose suitable outdoor furniture can provide comfortable and convenient outdoor life experience.